Please read carefully before securing your panels to the wall!Â
| 01 Plan the exact positioning of the panels on the wall. You will need to allow for an installation space of 3 mm between the sheets. This gap is essential. Real wood like WOO! will improve the quality of the atmosphere in the room by breathing, absorbing or releasing moisture to the air, while the dimensions of the wood will live a bit. WOO! panels have been designed to allow you to mix both bigger and smaller sizes with ease. 02 Before beginning the installation, clean the wall carefully. Cleaning is important for the best result. Measure the location of the first panel and mark it, for example with masking tape. 03 You’ll get a 3 mm gap between the panels by using the installation pieces included. 04 Peel the white protective tape from the fixing pieces behind the panel. The shiny surface found under the protective tape must be kept completely clean, so be careful not to touch it or get it dirty. Position the panel carefully over the correct place on the wall. Take care that the panel doesn’t touch the wall before you have checked the alignment, because it will start to stick immediately. When you know the location is right, press the corners of each panel to the wall for a minimum of 10 seconds. If the fixing tape for some reason gets dirty or damaged, you should replace it with a new one. You can purchase extra tape from the shop. 05 Repeat section 4. placing a 3mm installation piece between the panel already fixed and the next piece to get the gap needed between the sheets. Repeat sections 4. and 5. with further panels until your design is complete. |
Removing the panel from the wall refizing.
On removal one side of the fixing tape will remain attached to the underside of the panel, the other side to the wall. When changing the pattern of the panels simply press each panel into its new position - when you hear a snap, the panel will be firmly fixed in its new place.
